Bryan Jenkins
More ideas from Bryan
Come accorciare un bullone, tagliandolo con semplicità, usando un avvitatore, una lama da seghetto HSS e della #ferramenta

Come accorciare un bullone, tagliandolo con semplicità, usando un avvitatore, una lama da seghetto HSS e della #ferramenta

The Family Handyman - Screws DIY Tip of the Day. Use this quick and simple way to get a screw started in a hard-to-reach place. Just poke the screw through a piece of masking tape with the sticky side of the tape toward the head. Place the screwdriver in the slot, then fold the tape up onto the screwdriver. Once the screw is well started, pull the screwdriver loose and remove the tape. by marjorie

The Family Handyman - Screws DIY Tip of the Day. Use this quick and simple way to get a screw started in a hard-to-reach place. Just poke the screw through a piece of masking tape with the sticky side of the tape toward the head. Place the screwdriver in the slot, then fold the tape up onto the screwdriver. Once the screw is well started, pull the screwdriver loose and remove the tape. by marjorie

It's often the simple fixes that make a shop more enjoyable to work in. Here are some reader submitted tips for you to put to use.

It's often the simple fixes that make a shop more enjoyable to work in. Here are some reader submitted tips for you to put to use.

Sealed and Stored Here’s a slick tip to keep partially used caulk tubes well sealed and at hand. Fold a piece of duct tape over the open tube to seal it, leaving a few inches of extra tape. Drive a nail through the tape and hang the tube on pegboard.

Sealed and Stored Here’s a slick tip to keep partially used caulk tubes well sealed and at hand. Fold a piece of duct tape over the open tube to seal it, leaving a few inches of extra tape. Drive a nail through the tape and hang the tube on pegboard.