This DIY Floor Project was made from Plywood, we took 13 full sheets of Plywood and ripped the into 6 in wide and 8 ft long Planks, then glues down with also some finishing nails, Stained and Polyurethaned, Total square footage was 400, Total Cost of this Project was 300.00 and we did a Living Room, Bedroom and Hallway, , Now that's a $$$$$ Saving Project. .. https://www.facebook.com/pages/Trash-To-Treasures/261463607265438?ref_type=bookmark
This website has a few how to videos - it is called Man school. I really like it. How to build shelf brackets by michael bronco. http://www.manschoolprogram.com Build your own shelf brackets without spending more that a couple bucks. Materials needed: 1x2 and 1x3 pine, 3-or-4- penny finish nails, wood glue.
Build this handy stool in one hour and park it in your closet. You can also use it as a step to reach the high shelf. All you need is a 4 x 4-ft. sheet of 3/4-in. plywood, wood glue and a handful of 8d finish nails. Cut the plywood pieces according to the illustration. Spread wood glue on the joints, then nail them together with 8d finish nails. First nail through the sides into the back. Then nail through the top into the sides and back. Finally, mark the location of the two shelves and…
Go to the lumber yard & buy 1" thick x 10" wide premium white pine 8' boards at $0.85/linear foot. hand sand all the edges so they aren't sharp/look older. Then cut them in a staggered length & place down to assure u like the pattern. apply PL400 subfloor glue along the bottoms & lay them down butted up board to board (the sanded edges provided some small gaps between them for character.) he used a nail gun/compressor with finish nails for extra hold. Apply Watco Danish Dark Walnut Oil.
how to make a rustic pottery barn lantern [1 bundle] redwood garden stakes [1" x 2" x 12"] $6.25 redwood board [2" x 2" x 8'] $2.77 thick gauge wire $3.48 miter saw wood glue finishing nails clamps drill hammer or nail gun [if you're a bad ass] To start, you want to create the base of the lantern. I grabbed 5 redwood stakes and cut off the pointy end to a length of 8.5″
DIY continuous strand weaving looms made with plywood and 1" finishing nails. 3 1/2" and 7". 1/4" nail spacing. i used a band saw and a scroll saw, and my dremel in the drill press attachment to pre drill the holes.